PROBLEM SOLVING TASKSXEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE 11-25Step 3. Relatch the paper feeder assembly by pressing down on the brightgreen dot (see figure 11-32). Slide the paper tray completely backinto the printer.Figure 11-32.Relatching the paper feeder assemblyStep 4. Operate the system as usual. If you are still experiencing misfeeds,place a service call.Note:This procedure should be used only to correct aproblem, not as a routine maintenance procedure. Because thebelts are made of rubber, frequent cleaning with film remover willdry them out and cause them to fail prematurely. Film removermay be obtained from your Xerox service representative.Faults are cleared but the Attention light is still onIf you have cleared all faults that are listed on the printer controlconsole, but the Attention light is still on and the message “Output isstopped. See message at the System Display” appears on the printercontrol console, there may be an uncleared output fault. Check thesystem controller display. Follow the instructions in the outputmessage and press the Continue button.Printing does not continue when the Continue button is pressedIf the Continue button is pressed before all printer faults are cleared,the outstanding faults are changed to the status of masked faults(refer to the “Fault masking and the printer control console” sectionearlier in this chapter). If the printer status displayed in the messagearea of the printer control console is READY, but printing does notcontinue when you press the Continue button, touch the Fault Listicon on the printer control console to display the Fault List screen.(Refer to figure 11-1.) Clear any faults displayed on this screen andpress the Continue button again.
