xiInstallation PrecautionsEnvironmentCAUTION• Avoid placing the printer on or in locations which are unstable or not level. Such locations maycause the printer to fall down or fall over. This type of situation presents a danger of personalinjury or damage to the printer. .......................................................................................• Avoid locations with humidity or dust and dirt. If dust or dirt becomes attached to the powerplug, clean the plug to avoid the danger of fire or electrical shock. ......................................• Avoid locations near radiators, heaters, or other heat sources, or locations near flammableitems, to avoid the danger of fire. ....................................................................................• To keep the printer cool and facilitate changing of parts and maintenance, allow access spaceas shown below. Leave adequate space, especially around the side cover, to allow air to beproperly ventilated out of the printer. ...............................................................................• Always use the caster stoppers to stabilize the printer once it is in place to keep it from movingand/or falling over and causing injury. .............................................................................Other Precautions• Adverse environmental conditions may affect the safe operation and performance of theprinter. Install in an air-conditioned room (recommended room temperature: around 20 °C,humidity: around 65 % RH) and avoid the following locations when selecting a site for theprinter.• Avoid locations near a window or with exposure to direct sunlight.• Avoid locations with vibrations.• Avoid locations with drastic temperature fluctuations.• Avoid locations with direct exposure to hot or cold air.• Avoid poorly ventilated locations.• If the floor is delicate against casters, when this product is moved after installation, the floormaterial may be damaged.Left: 50 cm(19-11/16 inches)
