3.4 e-MPS3-23Deleting a Quick Copy JobAll quick copy jobs are automatically deleted when the printer is turned off. If you desire toexplicitly delete a stored quick copy job, proceed as follows:1111 Follow steps 1 through 8 in the above section to let the title of the job to be deleteddisplayed.2222 When the title of the job to be deleted is displayed, e.g. Report, below, press theENTER key. The cursor below the copy count starts to blink.3333 Press the V key repeatedly until Delete appears below the title.4444 Press the ENTER key. The stored quick copy job is deleted.3.4.2 Using Proof-and-HoldWhen you print multiple copies, this mode first prints one copy so that you can proof itbefore continuing to print the remaining copies. Since you can proof the printouts beforeprinting the remaining copies, wastage of paper can be reduced.The printer prints one copy and, at the same time, saves the print job on the hard disk/RAMdisk. You can also change the number of copies when resuming printing from the operatorpanel.When the printer is turned off, all stored jobs will be deleted.Printing Remaining Copies of a Proof and Hold JobPrinting a Proof-and-Hold job on the operator panel is similar to printing a quick copy job.See Printing Additional Copies using Quick Copy on page Chapter 3-22.>ReportCopies 001>ReportDelete
