3.4 e-MPS3-243.4.3 Printing a Private Print/Job RetentionIn private printing, you can specify that a job is not printed until you release the job from theoperator panel. At sending the job from the application software, you can specify a 4-digitaccess code in the printer driver. The job is released for printing by entering the access codeon the operator panel. Thus, this function ensures confidentiality of the print job.In the job retention mode, access codes are not mandatory, but can be set on the printerdriver if printing with the PIN security is required. Then, the access code must be entered onthe operator panel to print a stored job. Print data will be stored in the hard disk/RAM diskafter printing. See KX Printer Drivers Operation Guide for the driver settings.Releasing a Private/Stored Job1111 Press the MENU key.2222 Press the U or V key repeatedly until e-MPS > appears.3333 Press the Z key.4444 Press the U or V key repeatedly until >Private/Stored appears. The nameentered in the printer driver (Harold, in this example) also appears.5555 Press the ENTER key. A blinking question mark (?) appears before the user name.6666 Press the U or V key to display the desired user name (Arlen, in this example).7777 Press the ENTER key. The user name and the job name (Agenda, in this example)entered in the printer driver appear with a blinking question mark (?).8888 Press the U or V key to display the desired job title.e-MPS >>Private/StoredHarold>Private/Stored?Harold>Private/Stored?Arlen>Arlen?Agenda
