3.4 e-MPS3-303.4.5 Changing e-MPS ConfigurationYou can change the following parameters for e-MPS operation:• Maximum number of Quick Copy/Proof-and-Hold jobs• Maximum space assigned to temporary code jobs• Maximum space assigned to permanent code jobs• Maximum space assigned to virtual mailboxesNoteThe total amount of storage areas specified must not exceed the total size of the harddisk. Otherwise, you may only be able to accommodate print jobs of a smaller amountof print jobs than specified.Changing the Maximum Number of Quick Copy/Proof-and-Hold JobsThis changes maximum number of Quick Copy/Proof-and-Hold jobs from 0 to 50. Thedefault is 32.1111 Press the MENU key.2222 Press the U or V key repeatedly until e-MPS > appears.3333 Press the Z key.4444 Press the U or V key repeatedly until >e-MPS Configuration > appears.5555 Press the Z key.6666 Press the U or V key repeatedly until >>Quick Copy appears.7777 Press the ENTER key. A blinking cursor (_) appears.8888 Press the U or V key to increase or decrease the value at the blinking cursor. Thevalue can be set between 0 and 50. Use the Z and Y keys to move the cursor rightand left.9999 When the desired maximum number of jobs is set, press the ENTER key.e-MPS >>e-MPS >Configuration>>Quick Copy32>>Quick Copy32
