Xerox PHASER 5400 Advanced Features And Troubleshooting Manual

Also see for PHASER 5400: User guide Technical instructions Quick install guide Manual Installation instructions

Contents

Advanced Features and Troubleshooting Manual 23Control Panel MenusSubnet Mask Sets the four byte Subnet Mask address. (This menu item only appears if IPAddress Res is set to static.)Values:xxx.xxx.xxx.xxxwhere xxx = 000 to 255Note: Once the control panel shows Subnet Mask on the top line, use theValue keys (labeled 3 or 7) to scroll to the desired value at the cursorlocation. To move the cursor, use the Item keys (labeled 2 or 6). Thus, youcan change characters within the address rather than having to re-enter theentire address.Default Gateway Sets the four byte Default Gateway address. (This menu item only appears ifIP Address Res is set to static.)Values:xxx.xxx.xxx.xxxwhere xxx = 000 to 255This item only appears if IP Address Res. is set to Static.Note: Once the control panel shows Default Gateway on the top line,use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursorlocation. To move the cursor, use the Item keys (labeled 2 or 6). Thus, youcan change characters within the address rather than having to re-enter theentire address.Port Timeout Sets the time for determining when to end an incomplete print job and pollthe next port in the polling sequence. This menu item also causes an implicitjob end (such as Control D in PostScript or E in PCL) and invokes theemulation functions associated with this action (e.g., formfeed, reset, etc.).Values (in seconds):5 - 300 (default is 60)The value changes by 1 each time you press either Value key (labeled 3 or7). Hold down either key to scroll quickly through the values.Speed Sets the speed and half/full duplex mode of the 10/100 BaseT Ethernetinterface.Values:Auto (default)10/Half10/Full100/Half100/FullDDNS Enable Allows the printer to pass its Fully Qualified Domain Name (FQDN) to theDynamic Host Control Protocol (DHCP) server.Values:On (default)Off9100 Timeout Sets whether timeout is observed for the AppSocket Port 9100communications protocol.Values:On (default)OffEthernet Menu Items (cont'd.)