Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 3-83Error Messages and CodesPaper Remain at RegiPaper stuck in the registration section (or Main Paper Tray or Bypass Tray section)of the Printer was detected.Applicable Error• 077-100: Paper Remain at RegiInitial Actions• Check the media path for obstructions or debris.• Cycle printer power.• If the problem persists, use the following procedure.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Registration Sensor, PL2.3.5■ Harness Assembly RKN SNS,PL2.2.25/26■ MCU Board, PL7.2.2■ “Map 3 - Phaser 6000/6010” onpage 10-9■ “Phaser 6000/6010 Feeder” onpage 10-12■ “Phaser 6000/6010 Drive” onpage 10-13■ “Map 3 - WorkCentre 6015 MFP” onpage 10-23■ “WorkCentre 6015 MFP Feeder” onpage 10-26■ “WorkCentre 6015 MFP Drive” onpage 10-27Troubleshooting Procedure TableStep Actions and Questions Yes No1 Check connectors P/J12 and P/J120between the MCU Board and theRegistration Sensor.Are the connectors secure?Go to step 3. Reconnect theconnectors,then go tostep 2.2 Does the error persist? Go to step 3. Complete.3 Disconnect the MCU Board P/J21and the Registration Sensor P/J120.Check the Harness Assembly RKNSNS for continuity.Is the harness damaged?Go to step 4. Repair theharness.4 Disconnect the MCU Board P/J12.Is the voltage across ground andP/J12-1 +3.3VDC?Replace theRegistrationSensor(page 8-65).Replace theMCU Board(page 8-121).
