5-38 Xerox Internal Use Only Phaser 6000/6010 and WC 6015 MFPImage QualityTest PrintsA variety of test prints are available for troubleshooting print quality defects andto confirm proper printer operation. Test Prints can isolate printing problems to theMCU or Image Processor Board by using on board image data to isolate the twoboards. Test prints are also useful for stimulating asynchronous (dynamic) eventsrelated to the print process, or as a test for media path and media relatedproblems. Some other key features of test prints:• Is the only diagnostic utility to exercise the entire print cycle.• They are isolated from the operating system, and are run from firmware.• Isolates the Image Processor Board from the MCU Board.• Captures static or dynamic events.• Helps to isolate events that cause print artifacts or prevents printing.Test prints are selected from the list of available test prints in the Test Print menuof diagnostics.WorkCentre 6015 MFP Test PrintsTo print a test print:1. Start the Xerox Chart Print Tool.2. Check that the Paper Size is set correctly in the tool.3. Click the check box of the chart that you want to print.4. Click the Next button.5. Select either Network or USB for printing.6. Select the appropriate printer and click Next.7. Click Finish when complete.Pitch Configuration ChartPrint these charts to check for any regularlines or toner spots when encountering PQproblems.From the difference in the interval of regularlines or spots, you can determine the partsthat have caused the trouble.Pitch Chart Test Print
