Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 3-107Error Messages and CodesASIC FailureASIC Failure.Applicable Error• 124-333: ASIC FailureInitial Actions• Cycle printer power.• If the problem persists, use the following procedure.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ LED Driver Board, PL7.1.5■ LED/MCU Cable, PL7.1.6■ MCU Board, PL7.2.2■ “Map 3 - Phaser 6000/6010” onpage 10-9■ “Phaser 6000/6010 Xerographics” onpage 10-14■ “Phaser 6000/6010 Image ProcessorBoard” on page 10-18■ “Map 3 - WorkCentre 6015 MFP” onpage 10-23■ “WorkCentre 6015 MFP Xerographics”on page 10-28■ “WorkCentre 6015 MFP ImageProcessor Board” on page 10-32Troubleshooting Procedure TableStep Actions and Questions Yes No1 Check connectors P/J23 and P/J1 onthe MCU Board and LED DriverBoard.Are the connections secure?Go to step 3. Reconnect theconnectorsP/J23 and P/J1,and then go tostep 2.2 Does the error persist? Go to step 3. Complete.3 Disconnect the MCU Board P/J23and the LED Driver Board P/J1, andcheck the LED/MCU Cablecontinuity.Is the cable damaged?Replace theLED/MCUCable(page 8-111).Go to step 4.4 Replace the LED Driver Board(page 8-107).Does the error persist?Replace theMCU Board(page 8-121).Complete.
