Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 4-65TroubleshootingControl Panel TroubleshootingPrinter Does not Come to a “Ready” State1. Reseat connectors on the Image Processor Board.2. Refer to “DC Power Troubleshooting” on page 4-68.3. Replace the Control Panel (page 8-101 for Phaser 6000/6010, page 8-104 forWorkCentre 6015 MFP).4. Repair the Control Panel wiring harnesses.Ready LED is On, Display is Blank1. Remove and reseat connections to the Image Processor Board.2. Replace the Control Panel (page 8-101 for Phaser 6000/6010, page 8-104 forWorkCentre 6015 MFP).3. Repair the Control Panel wiring harness.4. Replace the Image Processor Board (page 8-114).Control Panel has FailedThe Control Panel either fails to illuminate or the buttons fail to operate after thepower switch is turned On.Initial Actions• Cycle printer power.• If the problem persists, follow the procedure below.Troubleshooting Procedure TableStep Actions and Questions Yes No1 Check connections between theImage Processor Board and theControl Panel.Are P/J407 and P/J220 secure?Go to step 2. Secure theconnections.2 Check the continuity of the ControlPanel Harness (PL1.1.5).Is the Control Panel Harnesscontinuity good?Go to step 3. Repair theharness, and ifthe errorpersists, go tostep 3.3 Replace the Control Panel(page 8-101 for Phaser 6000/6010,page 8-104 for WorkCentre 6015MFP).Does the error persist?Replace the IPBoard(page 8-114).Complete.
