3-50 Phaser 6300/6350/6360 Color Laser Printer Service ManualError Messages and CodesNon-Phaser 6300/6350/6360 FuserA CRUM-ID error indicates that a non-Phaser Fuser is installed.Applicable Status Code:Code 94: Fuser CRUM ID ErrorInitial Actions:■ Check that the Fuser latches are fully latched and cycle printer power.■ Check that the Fuser is the appropriate type for the model.■ If the problem persists, follow the procedure below.2 Replace the affected Toner Cartridge.Does the error persist after a genuineXerox Toner Cartridge is installed?Go to Step 3. Complete3 Check the CRUM Reader Boardconnection.Is P/J341 connected to the harness?Go to Step 4. Reconnect theCRUM ReaderBoard4 Replace the CRUM Reader Board.Does the error persist?Go to Step 5. Complete5 Check all pins on the RFID2 HarnessPL7.2.16 for continuity.1. Disconnect P/J341 and P/J3411.2. Check continuity betweenJ341<=>J3411.Go to Step 6. Replace theRFID2 Harness.6 Check all pins on the RFID HarnessPL7.2.17 for continuity.1. Disconnect P/J3411 and P/J34.2. Check continuity betweenP3411<=>J34.Replace theEngine ControlBoard(page 8-106).Replace the RFIDHarness.Troubleshooting Procedure Table (Continued)Step Actions and Questions Yes No
