Phaser 6300/6350/6360 Color Laser Printer Service Manual A-13Reference6360 Service Diagnostics Menu MapPhaserÆ6360 Service Diagnostic Menu MapPrint Service Menu Map Prints this menu map and exitsservice diagnostics.General Status Provides the following print engine status.StatusEngine Board ROM VersionPrinter ConfigurationAmbient Temp/HumidityFuser TemperatureFault HistoryTest Prints Prints Test Prints. Use the prints to identify, repair,and validate printer operation.Blank Page PrintStandard Test PrintCustom Test PrintCurrent Custom Test Print Set-upCustom Test Print ParametersMotors/Fans Tests Tests the motors and fans by energizing/de-energizing one at a time.Main MotorDuplex MotorFuser MotorDeveloper MotorHCF/LTA Motor 1HCF/LTA Motor 2Toner Motor YellowToner Motor MagentaToner Motor CyanToner Motor BlackRear FanFuser FanLVPS FanSensor/Switch Tests Test the sensors and switches byactuation and state changes of all sensors and switches.Interlock SwitchRegistration SensorExit SensorDuplex SensorFull Stack SensorBlack Toner (K) Low/Empty SensorCyan Toner (C) Low/Empty SensorMagenta Toner (M) Low/Empty SensorYellow Toner (Y) Low/Empty SensorBlack Toner Cart Present SwitchCyan Toner Cart Present SwitchMagenta Toner Cart Present SwitchYellow Toner Cart Present SwitchBlack Toner CRUM SensorCyan Toner CRUM SensorMagenta Toner CRUM SensorYellow Toner CRUM SensorTray 2 Low Paper SensorTray 3 Low Paper SensorTray 4 Low Paper SensorTray 5 Low Paper SensorSensor/Switch Tests -contíd-Tray 1 (MPT) No Paper SensorTray 2 No Paper SensorTray 3 No Paper SensorTray 4 No Paper SensorTray 5 No Paper SensorTransfer Roller Toner Full SensorImage Unit Installed/Not InstalledFuser Fan Rotation SensorRear Fan Rotation SensorLVPS Fan Rotation SensorMotor Rotation Sensor Main, Developer, FuserADC (CTD) SensorFuser NC SensorFuser STS SensorFuser NC Sensor AmplifierFuser Temp CompensationClutch Tests Tests the functionality of the clutches byenergizing/de-energizing one clutch at a time.Registration ClutchTray 1 (MPT) Turn ClutchTray 2 Turn ClutchTray 3 Turn ClutchTray 4 Turn ClutchTray 5 Turn ClutchSolenoid Tests Tests the solenoids by energizing/de-energizingone solenoid at a time.Tray 1 (MPT) Feed SolenoidTray 2 Feed SolenoidTray 3 Feed SolenoidTray 4 Feed SolenoidTray 5 Feed SolenoidMaintenance Cleans the Imaging Unit IDT rollers.Clean Imaging Unit IDT RollersNVRAM Access Read, set, or reset these values:PostScript NVRAM ResetMCU NVRAM Store/ RestoreToner Install DatesToner CRUM CheckCRU Life ResetCRU Life ReadIP Controller Diagnostics Tests basic functions of the ImageProcessor Controller Board.RAM Read/Write TestExit Exits service diagnostics and reboots the printer.For Authorized Service Personnel Use Only. Service Menufunctions are to be used by Xerox service personnel andauthorized service providers only. The printer can be damaged byimproper use of the built-in service tests.
