10/004-63Phaser 790/DocuColor 2006 REP 8.5Repairs and AdjustmentsInitial IssueREP 8.5 Feed SolenoidParts List on PL 3.1RemovalWARNINGTo avoid personal injury or shock, do not perform repair activities with the power switchon or electrical power applied to the machine.1. Switch off the machine power and disconnect the machine Power Cord.2. Remove the Rear Cover. (REP 14.6)WARNINGUse extreme care when working in the vicinity of the Option Bracket. The edges of theOption Bracket may be very sharp and could cause serious injury.CAUTIONThe Option Bracket and printer are connected by a harness. Be careful not to cause damage tothe wires when performing the following.3. Remove the Option Bracket. (Figure 1)Figure 1 Removing the Option Bracket4. Remove the Feed Solenoid. (Figure 2)Figure 2 Removing the Feed SolenoidReplacement1. Perform the procedure for removal in reverse.2. Install the Feed Solenoid so that the teeth of the Feed Gear mesh with the armature.1Remove the twoscrews and removethe Option Bracket1Disconnect theconnector3Remove the screwand Feed Solenoid2Release thewires fromthe clip
