10/002-62 Phaser 790/DocuColor 2006005-703Initial IssueStatus Indicator RAPs005-703 ADF No Feed RAPProcedureOpen, then close the Upper Chute Cover. The ADF Drive Motor cycles.Y NGo to Flag 3. Check for an open circuit. If the wire is OK, replace the ADF Control PWB(PL 17.2). If the problem remains, replace the ICM Main PWB (PL 16.2).Use a test lead or a jumper wire to short J 814 pin 2 to ground. The Document Set Indica-tor lights.Y NReplace the ADF Control PWB (PL 17.2).Disconnect P/J 711. There is +5 VDC from pin 2 of J711 to frame ground.Y NGo to Flag 1. Check for an open circuit.There is +5 VDC from pin 1 to pin 3 of J711.Y NGo to Flag 2. Check for an open circuit.Replace the Document Set Sensor (PL 17.5).
