10/004-88 Phaser 790/DocuColor 2006REP 8.40Initial IssueRepairs and AdjustmentsREP 8.40 Exit Transport AssemblyParts List on PL 9.1RemovalWARNINGTo avoid personal injury or shock, do not perform repair activities with the power switchon or electrical power applied to the machine.1. Switch off the machine power and disconnect the machine Power Cord.2. Remove the Top Cover. (REP 14.4)3. Remove the Rear Cover. (REP 14.6)CAUTIONThe plastic hinges of the Transport Cover can be easily damaged. Use care when performingthe following step.4. Remove the Exit Transport Cover. (Figure 1)Figure 1 Removing the Transport Cover5. Remove the Exit Transport Assembly. (Figure 2)Figure 2 Removing the Exit Transport AssemblyReplacement1. Perform the removal procedure in reverse.2. When replacing the Exit Transport Assembly, make sure that the plastic ears at the top(and at the bottom, below the fan) are positioned over the edge of the frame. (Figure 3)Figure 3 Exit Transport Assembly Positioning2Remove the fivescrews and the ExitTransport Assem-bly as shown1Disconnect theconnectors (2)Plastic EarsFrameEdge
