Loading Paper in the Bypass (Tray 5)NoteThe following procedure shows the Bypass (Tray 5) located on top of the 2-Tray OHCF.1. Gently extend the Bypass tray (Tray 5) as necessary to accommodate the paper.2. Hold the center of the paper guides and slide them to the desired paper size.3. Select the appropriate paper stock for your print/copy job.4. Open the ream of paper with the seam side facing up.5. Fan the sheets before loading them into the tray.6. Insert the paper or media into the tray until it stops.7. Adjust the paper guides so that they touch the edges of the stack.If enabled by your System Administrator, the Paper Tray settings/Tray Propertieswindow may be displayed on the UI.8. If the Paper Tray settings/Tray Properties window displays on the UI, confirm thecorrect tray to which it is printing and other information, including size, type (precuttab), and, if necessary, paper curl and/or alignment option.9. Select Confirm or OK to save the information and close the Paper Tray settings/TrayProperties window.Loading Tab Stock in the Bypass (Tray 5)Refer to the following tips before loading tab stock in the tray:• You can load either single straight collated or single reverse collated tab stock.• For network print jobs, refer to your print server customer documentation forinstructions on loading tab stock into a tray.• If a jam occurs while running tabbed sets, cancel the job and start again.1. Gently extend the Bypass tray (Tray 5) as necessary to accommodate the tab stock.2. Hold the center of the paper guides and slide them to the desired stock size.3. Fan the tab paper before inserting into the tray.4-9Xerox® Versant® 180 PressUser GuidePaper and Media
