Cleaning the Fuser AssemblyIf you see dry ink/toner debris on the back side of the print output, select and run theClean Fuser Assembly routine from the press UI to clean the fuser component andaddress this image quality issue caused by contaminants in the fuser.NoteIf you still notice contaminants on the back of the prints after running this procedure,contact Service. Dry ink/toner debris may be coming from the Transfer roll area insteadof the fuser.1. Press the Machine Status button on the UI.2. Select the Tools tab.3. Select Setup & Calibration > Clean Fuser Assembly.4. From the screen that displays, specify the paper tray to use and the number of blanksheets to print for the "Clean with Paper" method of removing the unfused dryink/toner.5. From Paper Supply, select the paper tray to use.NoteAny type of paper and size can be used. However, the smooth surface of coated paperdoes offer more contact area to the pressure roll.6. From Number of Sheets, select the number of blank sheets to print (1 to 5).NoteFor best results, run a minimum of 5 sheets.7. Select Save.8. Press the Start button.The system begins the cleaning process and displays a "successfully completed"message when finished.9. Select OK.NoteThe process with 5 sheets of paper will take approximately one minute.Replacing Consumable SuppliesThe following items are the Customer Replaceable Units (CRU) for the press. It isrecommended that you have a supply of these items available to eliminate down timewhen they need to be replaced.• Dry Ink/Toner cartridges (C, M, Y, K)• Drum cartridges (C, M, Y, K)• An empty Waste Dry Ink/Toner bottle• Suction FilterRefer to www.xerox.com for the latest consumable part numbers.5-5Xerox® Versant® 180 PressUser GuideMaintenance
