SpecificationsE.8NOTES:• Do not use letterhead paper printed with low-temperature inks, such as those used insome types of thermography.• Do not use raised or embossed letterhead.• The machine uses heat and pressure to fuse toner to the paper. Insure that any coloredpaper or preprinted forms use inks that are compatible with this fusing temperature(200 °C or 392 °F for 0.1 second).Paper SpecificationsPaper Output CapacityPaper Storage EnvironmentPaper storage environmental conditions directly affect the feed operation.Problems with feeding Ragged edges Use good quality paper.Category SpecificationsAcid content 5.5 pH or lowerCaliper 0.094 ~ 0.18 mm (3.0 ~ 7.0 mils)Curl in ream Flat within 5 mm (0.02 in.)Cut edge conditions Cut with sharp blades with no visible fray.Fusing compatibilityMust not scorch, melt, offset, or release hazardousemissions when heated to 200 °C (392 °F) for 0.1second.Grain Long grainMoisture content 4 % ~ 6 % by weightOutput Location CapacityFace-down output tray 150 sheets of 75 g/m 2 bond (20 lb) paperFace-up output slot 1 sheet of 75 g/m2 bond (20 lb) paperSymptom Problem with Paper Solution
