Scan OffsetWhen the Scan Offset feature is enabled, and a scan offset position is defined, themachine will ignore image information from the lead edge to the scan offset position.This enables you to eliminate unnecessary detail from the lead edge of an original.The scan offset position can be set up from 0 to 36.0 inches, in 0.1 inch increments.The factory default is Disabled.• Disabled: Scan offset will not be applied to the original• Enabled: A scan offset equivalent to the dimension you specify will be applied to theoriginal when it is scanned.1. Press the Services button on the Control Panel.The Services menu will display with Copy as an option.2. Select Copy.3. Select the Advanced Settings tab.4. Select Scan Offset.5. Select Enabled to define the amount of scan offset.6. Set up the scan offset, using either the numbers keypad or the scroll buttons.7. Select Save when finished.TIPWhen a Reduce/Enlarge ratio of other than 100% has been set up for the copyjob, the scan start position will be enlarged or reduced proportionately.2-23Xerox®Wide Format 6622 Solution™User GuidePrinting and Copying Documents
