Safety14 WorkCentre 3045 Multifunction PrinterUser GuideOperational SafetyYour printer and supplies were designed and tested to meet strict safety requirements. These includesafety agency examination, approval, and compliance with established environmental standards.Your attention to the following safety guidelines helps to ensure the continued, safe operation of yourprinter.Operational Guidelines• Do not remove the paper source tray that you selected in either the print driver or control panelwhile the printer is printing.• Do not open the doors when the printer is printing.• Do not move the printer when it is printing.• Keep hands, hair, neckties, and so on away from the exit and feed rollers.• Covers, which require tools for removal, protect the hazard areas within the printer. Do not removethe protective covers.Ozone ReleaseThis printer produces ozone during normal operation. The amount of ozone produced is dependent oncopy volume. Ozone is heavier than air and is not produced in amounts large enough to harm anyone.Install the printer in a well-ventilated room.For more information in the United States and Canada, go to www.xerox.com/environment . In othermarkets, please contact your local Xerox ® representative or go to www.xerox.com/environment_europe .Printer Location• Place the printer on a level, solid, non-vibrating surface with adequate strength to hold its weight.To find the weight for your printer configuration, see Physical Specifications on page 183.• Do not block or cover the slots or openings on the printer. These openings are provided forventilation and to prevent overheating of the printer.• Place the printer in an area where there is adequate space for operation and servicing.• Place the printer in a dust-free area.• Do not store or operate the printer in an extremely hot, cold, or humid environment.• Do not place the printer near a heat source.• Do not place the printer in direct sunlight to avoid exposure to light-sensitive components.• Do not place the printer where it is directly exposed to the cold air flow from an air conditioningsystem.• Do not place the printer in locations susceptible to vibrations.• For optimum performance, use the printer at elevations below 3100 m (10,170 ft.).
