Features28 WorkCentre 3045 Multifunction PrinterUser GuideNote: This menu appears on the WorkCentre 3045NI Multifunction Printer only when the printer isconnected to a wired network connection.Item DescriptionEthernet Specifies the Ethernet communication speed and the modes.TCP/IP Specifies the TCP/IP settings for the network.• IP Mode: Dual Stack or IPv4 Mode.• IPv4: Get IP Address, IP Address, Subnet Mask, or Gateway AddressProtocol Select Enable when using the protocol. Select Disable to make the protocol unavailable.• LPD: The default setting is Enable.• Port9100: The default setting is Enable.• WSD: The default setting is Enable.• SNMP: The default setting is Enable.• Status Messenger: The default setting is Enable.• CentreWare Internet Services: The default setting is Enable.• LLTD: The default setting is Enable.• Bonjour (mDNS): The default setting is Enable.Initialize NVM Initializes network data stored in non-volatile memory. After executing this function andrestarting the printer, all network settings are reset to their default values.Wireless Network SetupThis menu provides the selections for setting up the printer for wireless network connections.Note: This menu appears on the WorkCentre 3045NI Multifunction Printer when the printer is notconnected to a wired network connection.Item DescriptionStatus Displays the status of the wireless connection.Wireless Setup Specifies the method used for setting up the wireless connection:• Manual Setup• WPSReset Wireless Resets the wireless network settings to the default settings.TCP/IP Specifies the TCP/IP settings for the network.• IP Mode: Dual Stack or IPv4 Mode.• IPv4: Get IP Address, IP Address, Subnet Mask, or Gateway Address
