Key Operator ProgramsXerox WorkCentre C226 System Administration Guide 6-57Quick On-line sendingWhen this setting is turned on, the machine will call the other machine and start trans-mitting the document as soon as the first page is scanned. Transmission thereforetakes place at the same time as any further pages are being scanned. Normally thissetting is turned on.If you turn the setting off, transmission will not begin until all pages of the documenthave been scanned. Note that this setting does not apply to manual transmission.Recall in case of line busyWhen sending a document, this setting is used to select whether your machine willautomatically re-attempt the call when the other machine fails to answer or the line isbusy.Normally the machine is set to make 2 recall attempts at intervals of 3 minutes.The number of recall attempts and the interval between attempts that can be set ineach country are shown in the following table.Country Differentiation TableIf you do not want recalling to take place, touch the [TURN OFF RECALL] checkboxso that a checkmark appears.NOTE: Even if this setting is turned on, your machine will not re-attempt the call when adocument is sent by manual transmission. (See “Sending a Fax after Talking (ManualTransmission)” in your Xerox WorkCentre C226 User Guide.)Recall in case of communication errorWhen sending a document, this setting is used to select whether your machine will re-attempt the call if the transmission fails.Normally the machine is set to make 1* recall attempt at intervals of 1 minute.* Note that in Singapore, the machine is normally set to make 2 recall attempts.The number of recall attempts and the interval between attempts that can be set ineach country are shown in the following table.United Kingdom Australia, New Zealandand SingaporeThe number of recallattempts1 to 10 1 to 9The interval betweenattemptsany number of minutes from 1 to 15
