FPGA Design Demonstration BoardHardware User Guide 3-33with power off. Use the appropriate demonstration board socketfor your device.♦ U2 socket: XC4003E devices♦ U2 socket: XC4003E and XC3020A devices in a daisy chainwith the XC4003E at the head of the chain♦ U1 socket: XC3020A devices5. Set the mode switches.When you use the serial PROMs, the M0, M1, and M2 switchesmust be off. This setting causes the device to be in the activemaster serial mode. Set the MPE, SPE, and RST switches to thedesired positions. Refer to theTable 3-15 and the Table 3-16 forswitch settings required to configure a daisy chain.6. Load the FPGA.7. After you insert the PROM into the socket and set the configura-tion switches, apply power to the FPGA Demonstration Board.This step configures the FPGA; when the DONE pin goes High, itindicates that the design logic is active.8. Start your configuration software.For information on starting the Hardware Debugger software, see thefollowing section.Starting Hardware DebuggerThe following section includes a checklist for opening the HardwareDebugger software. For further information, consult the HardwareDebugger Guide.1. Open your Alliance or Foundation software.2. From within Xilinx Design Manager (version M1.0 or later), selectHardware Debugger from the tools menu. You can also start theHardware Debugger from the operating system prompt byentering the following command.hwdebugr design_nameWhen you start the Hardware Debugger, the port where the cableis plugged in is located, and the baud rate is set to the maximumallowed by the platform.
