Yaesu FT-817ND Operating Manual

Also see for FT-817ND: Brochure & specs Operating manual Technical supplement Operating manual Operating manual

8 FT-817ND Operating ManualLKALINE BATTERY I NSTALLATION AND U SEThe FT-817ND is supplied with the FBA-28 holder for Alkaline “AA” cells. A fresh set ofAlkaline cells should provide approximately 5.5 hours of reception under typical conditions.1. To install or replace the AA cells, first remove the battery cover from the bottom side ofthe transceiver. Slide the battery cover latch forward, as shown in the illustration, thenfold the battery cover upward and set it aside temporarily.2. Install the Alkaline AA cells as shown in the illustration, paying particular attention tothe correct polarity of the batteries.3. When all batteries have been successfully installed, replace the battery cover.INSTALLATIONImportant Notes When the transceiver is to be stored for a long period of time without use (longerthan ten days), remove the batteries from the FBA-28 holder, to avoid the possi-bility of battery leaking causing damage to the transceiver. Inspect the FBA-28battery holder occasionally for signs of corrosion or battery leakage, and removethe batteries immediately if any such damage is observed. The FBA-28 battery holder is designed for use solely with Alkaline type “AA”cells. Do not attempt to use Ni-Cd or other rechargeable cells in the FBA-28,because it does not contain the protection circuitry required when using recharge-able cells. When replacing batteries, replace all eight AA cells simultaneously with freshbatteries. When the battery voltage is approaching the value which indicates depletion isnear, the small “ ” will blink, indicating it is time to replace the batteries.