Yaesu FT-817ND Operating Manual

Also see for FT-817ND: Brochure & specs Operating manual Technical supplement Operating manual Operating manual

66 FT-817ND Operating ManualMenu Item 36 [MIC KEY]Function: Enable/disable CW keying by the microphone’s [UP]/[DWN] keys.Available Values: OFF/ONDefault: OFFWhen this Menu Item is set to “ON,” press the microphone’s [UP] key to send a “dot,” andpress the microphone’s [DWN] key to send a “dash” (while the built-in electronic keyer isengaged).Menu Item 37 [MIC SCAN]Function: Enable/disable scanning access via the microphone’s [UP]/[DWN] keys.Available Values: OFF/ONDefault: ONMenu Item 38 [OP FILTER]Function: Enable the optional filter (CW or SSB) path.Available Values: OFF/SSB/CWDefault: OFFAfter installing the optional filter, set this Menu Item to define the signal path correspondingtop the filter you have installed.Menu Item 39 [PKT MIC]Function: Adjust the audio input level from the TNC during 1200 bps Packet operation.Available Values: 0 ~ 100Default: 50Menu Item 40 [PKT RATE]Function: Set the transceiver’s circuitry for the Packet baud rate to be used.Available Values: 1200/9600 bpsDefault: 1200 bpsMenu Item 41 [RESUME]Function: Set the delay time for scanning resumption.Available Values: OFF/3/5/10 secondsDefault: 5 secWhen this Menu Item set to “OFF,” the scanner stops (without restarting) until you press the(SCN) key (or the microphone’s [UP]/[DWN] keys).Menu Item 42 [RPT SHIFT]Function: Set the magnitude of the Repeater Shift.Available Values: 0 ~ 99.99 MHzDefault: Depends on transceiver version, and the band in use.Each band’s repeater shift (HF/50/144/430 MHz) may be set independently.MENU O PERATION