Yaesu FTDX-9000MP Operation Manual

Also see for FTDX-9000MP: Operation manual Brochure & specs Update guide Update guide Update guide

Page 154 FT DX 9000MP OPERATION MANUALPressing any of these keys provides one-touch accessto the Amateur bands from 1.8 ~ 28 MHz. When theENT key has been pressed first, these keys thenserve as the frequency entry digits (“1” ~ “0”) duringdirect frequency entry.Pressing this key provides one-touch access to the 50MHz Amateur band. When the ENT key has beenpushed first, to engage direct frequency entry, press-ing this key sets the decimal point after the “MHz”portion of the frequency.This key turns the 28 MHz low-level (0 dBm) outputfrom the rear-panel’s TRV jack ON or OFF. When theTransverter function is turned on, both the TFT andthe main frequency display will show the convertedfrequency’s last two digits of the “MHz” field, accord-ing to the band programmed via Menu #034 (for ex-ample, if your transverted frequency is 144.200.00MHz, the display will show “44.200.00” as the oper-ating frequency.Pressing this key selects the “General Coverage” VFOregister, for reception outside the Amateur bands.Pressing this key momentarily engages the “direct fre-quency entry” mode of operation, whereby the keysdescribed in the (A) and (B) sections above are usedfor directly programming the operating frequency.Once the frequency has been successfully entered,press the ENT key once more to exit to the newly-selected frequency.For entering a frequency directly into the Sub (VFO-B) band register, press this key. Then use the keys de-scribed in sections (A) and (B) above for entering thedigits of the desired frequency; when done, press theV-B key once more to lock the newly- selected fre-quency into the Sub (VFO-B) band register.This key is used for gaining access to the Menu sys-tem, for configuring various transceiver characteris-tics. menu operation is described in detail, in thismanual, beginning on page 128.Important note:Pressing this key momentarily activates the Menu, andthe Menu selections will appear on the TFT screen;once you are finished, you must press and hold in theMNU key for two seconds to save any configura-tion changes (momentarily pressing MNU key toexit will not save the changes).These are the “Function” keys for the various func-tions associated with each page of the TFT’s opera-tional capability. The exact function of each key willdepend on the page selected.TFT F EATURE / C ONTROL D ETAILSTFT D ISPLAY U NIT (TFT-9000)