Yaesu FTDX-9000MP Operation Manual

Also see for FTDX-9000MP: Operation manual Brochure & specs Update guide Update guide Update guide

Page 16 FT DX 9000MP OPERATION MANUALI NSTALLATION AND I NTERCONNECTIONSCOMMONCOMMONDOTDOTDASHDASHKEY, K EYER , AND COMPUTER -D RIVEN K EYING I NTERCONNECTIONSThe FT DX 9000MP includes a host of features for the CW operator, the functions of which will be detailed in the “Opera-tion” section later. Besides the built-in Electronic Keyer, two key jacks are provided, one each on the front and rear panels,for convenient connection to keying devices.The Menu system allows you to configure the front ane rear panel KEY jacks according to the device you wish to connect.For example, you may connect your keyer paddle to the front panel KEY jack, and use Menu #41 for paddle input, whileconnecting the rear panel’s KEY jack to the keying line from your personal computer (which emulates a “straight key” forconnection purposes), and configure the rear panel jack using Menu #43.Both KEY jacks on the FT DX 9000MP utilize “Positive” keying voltage. Key-up voltage is approximately +5V DC, andkey-down current is approximately 1 mA.AdviceWhen connecting a key or other device to the KEY jacks, use only a 3-pin (“stereo”) 1/4” phone plug; a 2-pin plug willplace a short between the ring and (grounded) shaft of the plug, resulting in a constant “key-down” condition in somecircumstances.Pin 2GPS DATA INPin 5GNDCONNECTING A GPS R ECEIVERIf you connect a properly-equipped after-market GPS re-ceiver (not supplied) to the COM port on the back of thetransceiver, the “Rotator” page on the External display willautomatically include a Great Circle map centered on yourlocation.Connect a GPS receiver capable of output of NMEA-0183data to the COM port. The data line connects to Pin 2, andthe ground shield connects to Pin 5.This transceiver can support the GGA, GLL, and RMC DataSentences from the GPS unit.