31ENGLISHMonitor rear panelSpeaker (R) Speaker (L)PowercordEUROPE U.K. ONLYOptional Video Unit FunctionAdditional functions when the optional video unit is installed are as follows: ( )Use if thevideoequipmenthas anS videoinput terminalTo RGB,video and audioinput terminalsTo SCARTterminalTo S video outputterminalTo audio outputterminalsTo SCARTterminalsTo componentoutput terminalsTo componentinput terminalsTo compositeinput terminalTo audio outputterminalsTo audio inputterminals20 18 16 14 12 10 8 6 4 221 19 17 15 13 11 9 7 5 3 1VCRVCRDVD player DVD playerSet-Top BoxTo compositeoutput terminal(1) Make sure that the power switch of the monitor is turned off.(2) Make sure that the power switch of the imaging device is turned off.(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of thisdevice and the signal output terminal of the imaging device.INSTALLATION INSTRUCTIONSConnecting to a Video Imaging Device• If video equipment with an S video output terminal is used,connection with S video cable is recommended to provide finervideo quality. (If the S video input terminal and the video inputterminal of AV3 connect to the monitor at the same time, S videoinput would govern.)• If the OUTPUT (MONITOR) terminal is connected to an externalmonitor with a 75 Ohm terminal, it is possible to view the sameimage as on the main unit. But it is possible to monitor only thecomposite video signal from AV1, AV2, AV3, or AV4 input that isdisplayed on the screen at the time.DVI-STB and RGB component setupTo component videoequipment.Please use connectioncable suitable for the terminalform of video equipment.[An example of connecting video imaging devices]31 42~Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details. )Terminal RCA/SCART DVI D-sub RemarksSignal CVBS S-video Component RGB PC STB RGB ComponentAV1AV2 Refer to Setup Menu.AV3AV4 Refer to Setup Menu.RGB1 Refer to Setup Menu.RGB2 Refer to Setup Menu.( : Available)4038383939