8 Start-upDanger!Defective connections can cause the motor to start unexpectedly or lead to uncontrolled motormovements.Reversed connections cause the motor to rotate in the wrong direction. That can cause seriousmachine damage.CAUTION!Caution!Incorrectly wired connections can destroy the electrical / electronic components.Electrostatic discharges can be hazardous to the electronic components and lead to errors in thesoftware.You must comply with the following points to prevent machine damage or life-threatening injurieswhen commissioning the machine:• Only suitably qualified personnel are to be entrusted with the commissioning of the device. Theymust comply with the safety instructions.• Before starting work, make sure all tools and external parts have been removed from the machine.• Activate all safeguards and the emergency-off switches before commissioning.• Make sure no unauthorized persons are in the machine working area and that no other persons canbe endangered when the installation is started up.• inspect the electrical connections before the first start• Pay special attention to the protective measures (e.g. grounding, ...) for the electrostaticallyendangered components.• Also read the chapter "General Safety Instructions".InformationThis commissioning assumes the factory settings for the digital inputs and outputs, encoder inputs andmonitoring contacts have not been modified!Requirements for error-free commissioning:• Mains line is connected• Motor is connected• Brake chopper or Brake resistor are connected• Controller and monitoring inputs are connected• Encoder is connectedInformationStartup takes place in the basic level. To go to the advanced level, press the key long (see chapter"Opeation and Parameterisation / The different operating levels") or go to the Startup menu and setthe USR_LEV = Advancedparameter.Start-up|-" USR_LEV Advanced|-" AdvancedUser level8.1 Preconfigured inverterInverters preprogrammed by ZIEHL-ABEGG are provided with the following information plate on thefaceplateInformationPreset parametersPreset paramtersIn these units, the parameters are factory preset, based on customer specific information. Enteringparameters is no longer necessary but the parameters must be checked before commissioning!Original operating instructionsZETADYN 3C Start-upR-TBA08_03-GB 1619 Part.-No. 00163322-GB57/204
