Manuals database logo
manualsdatabase
Your AI-powered manual search engine

OHAUS DV215CD manuals

DV215CD first page preview

DV215CD

Brand: OHAUS | Category: Scales
Table of contents
  1. Introduction
  2. Special Tools and Test Equipment Required
  3. Test Masses Required
  4. Specifications
  5. Diagnosis
  6. Balance Will Not Turn On
  7. Balance Does Not Respond to Front Panel Controls
  8. Balance Cannot Calibrate Using External Weights
  9. Balance Cannot Calibrate Internally
  10. Error Codes
  11. Housing Disassembly/Opening the Balance
  12. Display Assembly Parts List
  13. Removing screws to separate Display Housing from bottom of balance
  14. Display Balance Load Cell Cover
  15. Discovery Balance Printed Circuit Board (PCB)
  16. Incal Weight Hardware Disassembly
  17. The InCal Weight Cover sits beneath the Display Cable Shield Plate
  18. Removing and Replacing Calibration Motor Assembly
  19. Calibration Motor Assembly
  20. Load Cell Removal
  21. Lifting off the PCB and its Mounting Plate from the Load Cell
  22. Load Cell with cover removed
  23. Load Cell removed
  24. Load Cell Disassembly
  25. Screws on bottom Flexure Arm assembly
  26. Service Toolset, Part No. 80030340
  27. Thumb screws and Hanger on top of Load Cell
  28. Load Cell with Load Flexure, 2 screws and 4 washers removed
  29. Lifting Ratio Beam to insert Brass Rod
  30. Removing screws from PCB. (Note stepped washer under rear screw)
  31. Up/Down Stop Plate
  32. Removing Thumb screws that hold Hanger in place
  33. Load Cell Cleaning
  34. Load Cell Assembly
  35. Yoke aligned with frame side-to-side, and flush with frame on front
  36. Hanger installed, with Brass Fixture and Brass Brackets
  37. Magnet Cover has oblong hole that clears Ratio Beam's stop tab
  38. Up/Down Stop Plate which rests on Magnet Cover
  39. Installing the bottom Flexure Arm
  40. Load Flexure, aluminum washers, steel washers and screws
  41. Hanger with Thumb screws removed
  42. Note stops on sides of bottom Load Cell Cover
  43. Top Load Cell Cover rests flush against bottom cover
  44. Load Cell Chassis with keyway at point of triangle
  45. Replacing Load Cell Cover
  46. Placing PCB Mounting Plate on Load Cell
  47. Installing Weights and Weight Holders
  48. Correct position of Display Cable under Display Cable Shield Plate
  49. Securing PCB Cover
  50. Models Segment Display Test
  51. Adjusting Off Center Load
  52. Repeatability Test
  53. Linearity Test
  54. RS232 Interface Test
  55. COM1 Interface Pin Connections
  56. RS232 Commands
  57. Print Test
  58. Parts List for Discovery Housing
  59. Discovery Display Assembly
  60. Discovery Internal Parts Outside Load Cell
  61. Discovery Load Cell Parts
Related products
DV214CDV314CDV114Ci-DFD500MAV212i-DFDCD-11AV213AV212R
OHAUS categories
More OHAUS categories
Manuals database logo
manualsdatabase
Your AI-powered manual search engine