CHAPTER 3 REPAIR PROCEDURES3.2.5 Installing the Load Cell11. Install the InCal Weight Assembly:11.1. Carefully remove any dust or debris from the Weights, Weight Holders, andtheir environment, using alcohol on a clean cloth.11.2. Install the Weights and Weight Holders.Note:A clean glove should be worn when handling Weights.Figure 3-97. Installing Weights and Weight Holders.11.3. Place the InCal Weight Cover over the Weights, aligning the screw holes leftand right. (The screws will be installed in the Display Cable Shield Plate,which rests on top of the InCal Weight Cover.)Figure 3-98. Proper position of InCal Weight Cover.Ohaus Corporation www.ohaus.com 3-48 Discovery Balance Service Manual