CHAPTER 3 REPAIR PROCEDURES3.2.2 Load Cell DisassemblyBefore proceeding with Load Cell disassembly, secure the Ratio Beam with stabilizing rods fromthe Service Toolset in the front and rear. This will lock Ratio Beam to the yoke and prevent itfrom falling down when the Up/Down Stop Plate is removed. Proceed as follows:15. On the back of the Load Cell, lift the Ratio Beam and insert the brass rod under it.Figure 3-46. Lifting Ratio Beam toinsert Brass Rod. Figure 3-47. Brass Rod installed.16. On the front of the Load Cell, screw in the Threaded Rod until it touches theRatio Beam.Threaded RodFigure 3-48. Screwing in Threaded Rodon front of Load Cell.Ohaus Corporation www.ohaus.com 3-26 Discovery Balance Service Manual