CHAPTER 3 REPAIR PROCEDURES3.2.5 Installing the Load Cell12. After putting the Weight Cover on, connect the Display Cable to the main PCB.Carefully position the cable so it fits under the Display Cable Shield Plate.13. Place the Display Cable Shield Plate over the InCal Weight Cover, carefully checkingthat the flat Display Cable fits in the raised groove.14. Before tightening the screws in the Display Cable Shield Plate, check that the PanSocket is centered in the hole. Then tighten the screws. (See Figure 3-99.)Display Cable Shield Plate ScrewsPan SocketFigure 3-99. Inserting screws in Display Cable Shield Plate,after checking that Pan Socket is centered in hole in middle of Plate.Display Cable runningunder Display CableShield PlateFigure 3-100. Correct position of Display Cableunder Display Cable Shield Plate.Discovery Balance Service Manual 3-49 Ohaus Corporation www.ohaus.com