CHAPTER 3 REPAIR PROCEDURES3.2.4 Load Cell Assembly21. Set the Load Cell on its back frame and position the Load flexure with elongated holeon the bottom.SteelwashersLoad Flexurewith elongatedscrew hole atbottomAluminumwashersScrewsElongated screwhole goes on thebottom.Figure 3-80. Load Flexure,aluminum washers, steelwashers and screws.Figure 3-81. Load Flexure on top of Hanger, withelongated screw hole at bottom.22. Gently tighten the upper screw, then the lower screw.NOTE:If Load Flexure begins to rotate when tightening screws, STOP IMMEDIATELY,to avoid bending or breaking the Flexure. If Flexure bends, replace it.Ohaus Corporation www.ohaus.com 3-40 Discovery Balance Service Manual
