CHAPTER 3 REPAIR PROCEDURES3.2.1 Load Cell RemovalFigure 3-26. Load Cell with cover removed.11. Remove the Cantilever Arm by applying slight downward pressure with the fingersand press upward with the thumb, then sliding away from the Load Cell.Cantilever ArmFigure 3-27. Removing Cantilever Arm from Load Cell.12. Tilt the balance onto its back and remove the 3 screws that secure the Load Cell tothe Bottom Housing.Figure 3-28. Bottom Housing of Load Cell.Screws securing Load Cellto Bottom HousingOhaus Corporation www.ohaus.com 3-18 Discovery Balance Service Manual
