86 CHAPTER 2: INSTALLING SYSTEM HARDWARE COMPONENTSConnecting anAnalog TerminalAdapterIf you are installing one or more Analog Terminal Adapters (ATA), installthem after installing chassis cards.To install an ATA:1 Connect the analog telephone or fax machine to the analog port on theATA. The analog port on a 3C10120B ATA has a picture of an analogtelephone beside it. See Figure 31. The analog port on a 3C10400 ATA islabeled POTS (Plain Old Telephone Service). See Figure 32.The Analog Terminal Adapter may require a telephone connector for useoutside North America. Contact your supplier for more information oncountry-specific requirements.2 Connect the Ethernet port on the ATA to the LAN. The Ethernet port on a3C10120B ATA is the connector on the far left side. On the 3C10400ATA, the Ethernet port is labeled LAN.Figure 31 3C10120B ATA ConnectorsFigure 32 3C10400 ATA Connectors3 You can optionally connect a PC (or other Ethernet device) to theEthernet hub port on the ATA. The 3C10120B Ethernet hub port has apicture of an NBX Business telephone beside it. The Ethernet hub port onthe 3C10400 ATA is labeled PC.4 Connect the AC power adapter to the AC power connector on the ATA.If you are using a powered Ethernet cable instead of the AC adapter, see“Using Power over Ethernet with an ATA” next.5 Plug the AC power adapter into a wall outlet.6 Auto Discover the ATA. For more information about Auto Discover, see“Using Auto Discover for Initial System Configuration” on page 91.POTS LAN PCIOIO124 VDC
