494 APPENDIX D: CONNE XTIONS H.323 GATEWAYYou can assign any of the first ten speed dial numbers in each type group,system or personal, to any Access button on a telephone. For moreinformation, see Chapter 6 of the NBX Telephone Guide.Setting Up Speed DialsThe following procedure assumes that you are logged on to NetSet as anadministrator, and that you know the H.323 port extensions that wereestablished during installation.To set up speed dials:1 Click PSTN Gateway Configuration > Analog Line Cards.2 Note the extension number of each listed H.323 port.3 Click Feature Settings > System Speed Dials tab.4 To complete the fields:a Note a speed dial number. (One-button dialing requires system speeddial numbers 700 through 709.b In the New Number field, type an H.323 extension, or an 8 (forextension list), followed by an IP address, or a system name. Examplesare:8192* 168 *1 *15 * 273# (IP address plus extension)8192.168.1.15 *273# (IP address plus extension)8273@h323.nbx.com# (extension plus host name)8h323.nbx.com# (host name, defaults to AA)Use those characters shown here, that is, no spaces, hyphens or & signs.c In the Comment field, enter a description with up to 30 characters,such as Tie-line to NYC, and then click Apply.5 Verify the speed dial entry by pressing the Feature button followed by thenew speed dial number.One Button Access You can configure an Access button on a system to dial a complete H.323(or switched) dial sequence.This procedure assumes that all buttons available for one-button accessare configured in the first ten system (or personal) speed dial locations.
