3Com Router 3000 Ethernet FamilyConfiguration Guide Chapter 7 IPSec Configuration3Com Corporation7-277.3 Displaying and Debugging IPSec7.3.1 Displaying and Debugging over IPSec Module on V 2.41 PlatformI. Displaying and debugging IPSec configurationAfter the above configuration, execute display command in any view to display therunning of the IPSec configuration, and to verify the effect of the configuration.Execute debugging command in user view for the debugging of IPSec configuration.Table 7-31 Display and debug IPSecOperation CommandDisplay Security Association relatedinformationdisplay ipsec sa [ brief | remote ip-address| policy policy-name [ seq-number ] |duration ]Display statistical information onIPSec processed packet display ipsec statisticsDisplay IPSec proposal display ipsec proposal [ proposal-name ]Display IPSec policy display ipsec policy [ brief | namepolicy-name [ seq-number ] ]Display IPSec policy template display ipsec policy-template [ brief |name policy-name [ seq-number ] ]Display information about thespecified or all DPD structures display ike dpd [ dpd-name ]Enable IPSec debugging functiondebugging ipsec { all | sa | packet [ policypolicy-name [ seq-number ] | parametersip-address protocol spi-number ] | misc }Disable IPSec debugging functionundo debugging ipsec { all | sa | packet[ policy policy-name [ seq-number ] |parameters ip-address protocolspi-number ] | misc }Enable IKE DPD debugging debugging ike dpdDisable IKE DPD debugging undo debugging ike dpdII. Clearing IPSec packet statistical informationThis command clears IPSec packet statistical information. All statistical information isset to zero.Perform the following configuration in the user view.
