3Com Router 3000 Ethernet FamilyConfiguration Guide Chapter 12 IP Unicast Policy Routing Configuration3Com Corporation12-4The user can specify multiple next hops or set several outbound interfaces. In this case,the forwarding of packets will be shared among multiple parameters, namely, eachpacket is sent on each next hop or outbound interface in turn. This is only applicable tomultiple parameters configured of one kind. If the outbound interfaces and next hopsare both configured, only the outbound interface is set to perform the load sharing.By default, no apply clause is defined.12.2.2 Enabling Policy RoutingI. Enabling or Disabling Local Policy RoutingEnable or disable local policy routing in the system view. Only one local policy can beenabled.Table 12-4 Enable/disable local policy routingOperation CommandEnable local policy routing ip local policy route-policy policy-nameDisable local policy routing undo ip local policy route-policy policy-nameBy default, local policy routing is disabled.II. Enabling or Disabling Policy Routing on the InterfaceEnable or disable policy routing on a specified interface. At most one policy can bereferenced on each interface.Perform the following configuration in interface view.Table 12-5 Enable/disable policy routing on the interfaceOperation CommandEnable policy routing on the interface ip policy route-policy policy-nameDisable policy routing on theinterface undo ip policy route-policy policy-nameBy default, policy routing is disabled on the interface.12.3 Displaying and Debugging IP Unicast Policy RoutingAfter the above configuration, execute the display command in all views to display therunning of the IP Unicast Policy Routing configuration, and to verify the effect of theconfiguration.Execute the debugging command in user view for the debugging of IP Unicast PolicyRouting.
