3Com Router 3000 Ethernet FamilyConfiguration Guide Chapter 3 RIP Configuration3Com Corporation3-16Table 3-19 Configure multi-instanceOperation CommandEnter MBGP address family view of RIP ipv4-family [ unicast ] vpn-instancevpn-instance-nameRemove the configuration of MBGPaddress family view of RIPundo ipv4-family [ unicast ]vpn-instance vpn-instance-nameAll configurations in MBGP address family view will be removed after the undoipv4-family command is executed.MBGP address family view applies to BGP/MPLS VPN. For related description, refer to"MPLS VPN Configuration" chapter in module "MPLS" of this manual.3.2.18 Configuring TRIPPerform the following configuration in interface (except for Ethernet, ATM, loopback,tunnel, and bridge-template interfaces) view.Table 3-20 Configure TRIPOperation CommandEnable TRIP rip triggeredDisable TRIP undo rip triggeredBy default, TRIP is disabled.TRIP is compatible with RIP-1 and RIP-2 extensions.3.3 Displaying and Debugging RIPAfter the above configuration, execute display command in all views to display therunning of the RIP configuration, and to verify the effect of the configuration. Executedebugging command in user view to debug the RIP module.Table 3-21 Display and debug RIPOperation CommandDisplay the current RIP running stateand configuration information display ripDisplay information about RIPinterfaces.display rip interface [ vpn-instancevpn-instance-name ]Display the configuration of RIP MPGPaddress familydisplay rip vpn-instancevpn-instance-name
