3Com Router 3000 Ethernet FamilyConfiguration Guide Chapter 4 MPLS L2VPN Configuration3Com Corporation4-10z Create SVC connectionRefer to section 4.2 “Configuration of MPLS L2VPN in CCC Mode” for the first threesteps.4.3.1 Configuring PE-PE TunnelCurrent two types of tunnels are available, GRE tunnel and LSP tunnel.I. Configuring GRE tunnelTable 4-8 Configure GRE tunnelOperation CommandCreate a tunnel interface Interface tunnel numConfigure tunnel source address (tunnel interface view) source X.X.X.XConfigure tunnel destination address (tunnel interfaceview) destination X.X.X.XII. Configuring LSP tunnelTable 4-9 Configure LSP tunnelOperation CommandConfigure LSP creation policy lsp-trigger { all | ip-prefix ip-prefix }Caution:Since LSP is created by MPLS according to routing information, to create a LSP to thedestination address, first make sure host routing information of every PE is transmittedto the peer by routing protocol.4.3.2 Creating SVC ConnectionPerform the following configurations in interface view.Table 4-10 Create an SVC connectionOperation CommandCreate an SVCconnectionmpls static-l2vc destination destination-router-idtransmit-vpn-label transmit-label-valuereceive-vpn-label receive-label-value
