122 CHAPTER 6: IP S ERVICES COMMANDSExamples — The following command shows the status and port numberfor the HTTPS management interface to the WX switch:WX4400# display ip httpsHTTPS is enabledHTTPS is set to use port 443Last 10 Connections:IP Address Last Connected Time Ago (s)------------ ----------------------- ------------10.10.10.56 2003/05/09 15:51:26 pst 349Table 30 describes the fields in this display.See Also■ “clear ip telnet” on page 112■ “display ip telnet” on page 125■ “set ip https server” on page 139■ “set ip telnet” on page 146■ “set ip telnet server” on page 146Table 30 Output for display ip httpsField DescriptionHTTPS isenabled/disabledState of the HTTPS server:■ Enabled■ DisabledHTTPS is set to use port TCP port number on which the WX switch listens forHTTPS connections.Last 10 connections List of the last 10 devices to establish connections tothe WX switch’s HTTPS server.IP Address IP address of the device that established theconnection.If a browser connects to a WX switch from behind aproxy, then only the proxy IP address is shown. Ifmultiple browsers connect using the same proxy, theproxy address appears only once in the output.Last Connected Time when the WX switch established the HTTPSconnection to the WX switch.Time Ago (s) Number of seconds since the device established theHTTPS connection to the WX switch.
