display log trace 493Syntax — display log trace [{+|-|/}number-of-messages][facility facility-name] [matching string][severity severity-level]■ trace — Displays the log messages in the trace buffer.■ +|-|/number-of-messages — Displays the number of messagesspecified as follows:■ A positive number (for example, +100), displays that number of logentries starting from the oldest in the log.■ A negative number (for example, -100) displays that number of logentries starting from newest in the log.■ A number preceded by a slash (for example, /100) displays thatnumber of the most recent log entries in the log, starting with theleast recent.■ facility facility-name — Area of MSS that is sending the logmessage. Type a space and a question mark (?) after display logtrace facility for a list of valid facilities.■ matching string — Displays messages that match a string—forexample, a username or IP address.■ severity severity-level — Displays messages at a severity levelgreater than or equal to the level specified. Specify one of thefollowing:■ emergency — The WX switch is unusable.■ alert — Action must be taken immediately.■ critical — You must resolve the critical conditions. If theconditions are not resolved, the WX can reboot or shut down.■ error — The WX is missing data or is unable to form a connection.■ warning — A possible problem exists.■ notice — Events that potentially can cause system problems haveoccurred. These are logged for diagnostic purposes. No action isrequired.■ info — Informational messages only. No problem exists.■ debug — Output from debugging.Defaults — None.Access — Enabled.
