set port type ap 83country-specific regulations on the WX switch. See “set systemcountrycode” on page 51.For an MAP that is indirectly connected to the WX switch through anintermediate Layer 2 or Layer 3 network, use the set dap command toconfigure a Distributed MAP.Before changing the port type from ap to wired-auth or fromwired-auth to ap, you must reset the port with the clear port typecommand.Syntax — set port type ap port-list model {ap2750 | mp-52 |mp-101 | mp-122 | mp-241 | mp-252 | mp-262 | mp-341 | mp-352}poe {enable | disable} [radiotype {11a | 11b | 11g}]■ port-list — List of physical ports.■ model {ap2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 |mp-262 | mp-341 | mp-352} — MAP access point model:■ ap2750 — Contains one radio that can be configured throughsoftware for 802.11a or 802.11b/g.■ mp-52 — Contains one 802.11a radio and one 802.11b radio, withadjustable external antennas.■ mp-101 — Contains one radio that can be configured throughsoftware for 802.11a or 802.11b.■ mp-122 — Contains one 802.11a radio and one 802.11b/g radio.■ mp-241 — Contains one radio that can be configured throughsoftware for 802.11a or 802.11b/g.■ mp-252 — Contains one 802.11a radio and one 802.11b radio.■ mp-262 — Contains one 802.11a radio and one 802.11b radio,and a connector for an external antenna for the 802.11b/g radio.■ mp-341 — Contains one radio that can be configured throughsoftware for 802.11a or 802.11b/g, and a connector for anexternal antenna for the 802.11b/g radio.■ mp-352 — Contains one 802.11a radio and one 802.11b radio,and a connector for an external antenna for the 802.11b/g radio.■ poe enable | disable — Power over Ethernet (PoE) state.
