display {ap | dap} config 235Defaults — None.Access — All.History — Introduced in MSS Version 3.0.Usage — MSS lists information separately for each MAP access point.Examples — The following example shows configuration information foran MAP access point on WX port 2:WX1200# display ap config 2Port 1: AP model: AP2750, POE: enable, bias: high, name: MAP01boot-download-enable: YESload balancing group: noneRadio 1: type: 802.11g, mode: enabled, channel: dynamictx pwr: dynamic, profile: defaultauto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10The following example shows configuration information for a DistributedMAP access point configured on connection 1:WX4400# display dap config 1Dap 1: Serial-Id: M9DE48B012F00, MAP model: AP2750, bias: high, name: DAP1boot-download-enable: YESRadio 1: type: 802.11a, mode: disabled, channel: dynamictx pwr: 11, profile: defaultauto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10Table 45 describes the fields in this display.Table 45 Output for display ap configField DescriptionPort WX port number.Note: This field is applicable only if the MAP is directlyconnected to the WX switch and the WX switch’s port isconfigured as a MAP access port.DAP Connection ID for the Distributed MAP.Note: This field is applicable only if the MAP is configured onthe WX switch as a Distributed MAP.Serial-Id Serial ID of the MAP access point.Note: This field is displayed only for Distributed MAPs.
