display log buffer 491■ severity severity-level — Displays messages at a severity levelgreater than or equal to the level specified. Specify one of thefollowing:■ emergency — The WX switch is unusable.■ alert — Action must be taken immediately.■ critical — You must resolve the critical conditions. If theconditions are not resolved, the WX can reboot or shut down.■ error — The WX is missing data or is unable to form a connection.■ warning — A possible problem exists.■ notice — Events that potentially can cause system problems haveoccurred. These are logged for diagnostic purposes. No action isrequired.■ info — Informational messages only. No problem exists.■ debug — Output from debugging.Defaults — None.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — The debug level produces a lot of messages, many of whichcan appear to be somewhat cryptic. Debug messages are used primarilyby 3Com for troubleshooting and are not intended for administrator use.Examples — Type the following command to see the facilities for whichyou can view event messages archived in the buffer:WX4400# display log buffer facility ? name> Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP,ASO, BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD,IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE,SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP,RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.The following command displays logged messages for the AAA facility:WX4400# display log buffer facility AAAAAA Jun. 25 09:11:32.579848 ERROR AAA_NOTIFY_ERR: AAA got SMspecial event (98) on locality 3950 which is gone
