set radio-profile auto-tune power-backoff- timer 279Access — Enabled.History — Introduced in MSS Version 3.0.Usage — 3Com recommends that you use an interval of at least 300seconds (5 minutes).RF Auto-Tuning can change a radio’s channel before the channel intervalexpires in response to RF anomalies. Even in this case, channel changescannot occur more frequently than the channel holddown interval.If you set the interval to 0, RF Auto-Tuning does not reevaluate thechannel at regular intervals. However, RF Auto-Tuning can still change thechannel in response to RF anomalies.Examples — The following command sets the channel interval for radiosin radio profile rp2 to 2700 seconds (45 minutes):WX4400# set radio-profile rp2 auto-tune channel-interval 2700success: change accepted.See Also■ “set radio-profile auto-tune channel-config” on page 276■ “set radio-profile auto-tune channel-holddown” on page 277set radio-profileauto-tunepower-backoff-timerSets the interval at which radios in a radio profile reduce power aftertemporarily increasing the power to maintain the minimum data rate foran associated client. At the end of each power-backoff interval, radiosthat temporarily increased their power reduce it by 1 dBm. The powerbackoff continues in 1 dBm increments after each interval until the powerreturns to expected setting.Syntax — set radio-profile name auto-tune power-backoff-timerseconds■ name — Radio profile name.■ seconds — Number of seconds radios wait before lowering the powerby 1 dBm. You can specify from 0 to 65535 seconds.Defaults — The default power-backoff interval is 10 seconds.Access — Enabled.
