set service-profile wep active-unicast- index 311set service-profilewep active-unicast-indexSpecifies the static Wired-Equivalent Privacy (WEP) key (one of four) touse for encrypting unicast frames.Syntax — set service-profilename wep active-unicast-index num■ name — Service profile name.■ num — WEP key number. You can enter a value from 1 through 4.Defaults — If WEP encryption is enabled and WEP keys are defined,MAP radios use WEP key 1 to encrypt unicast frames, by default.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — Before using this command, you must configure values for theWEP keys you plan to use. Use the set service-profile wep key-indexcommand.Examples — The following command configures service profile sp2 touse WEP key 4 for encrypting unicast traffic:WX4400# set service-profile sp2 wep active-unicast-index 4success: change accepted.See Also■ “set service-profile wep active-multicast- index” on page 310■ “set service-profile wep key-index” on page 311set service-profilewep key-indexSets the value of one of four static Wired-Equivalent Privacy (WEP) keysfor static WEP encryption.Syntax — set service-profile name wep key-index num key value■ name — Service profile name.■ key-index num — WEP key index. You can enter a value from 1through 4.■ key value — Hexadecimal value of the key. You can enter a10-character ASCII string representing a 5-digit hexadecimal numberor a 26-character ASCII string representing a 13-digit hexadecimal
