3Com 6416SW Installation And User Manual

Isolating and Reconnecting ATM Media ModulesUse the SET MODULE command to:Isolate and reconnect ATM media modules to the ATM network.Enable and disable ATM media modules that are connected to the network.When you isolate an ATM media module from the network, it remains in Reset modeand no activity takes place on it. Its current configuration settings cannot be accessedby the network. In order to use the module for ATM data transmission, you mustreconnect it to the network and enable it.Fault ManagementThe 6416SW fault management function allows the administrator to report informationon ATM media modules and ports.For example, to display the status of all ATM ports in the 6416SW, you enter:ONcoreATM> show port all [ENTER]Port display for module ONcore ATM 1 Mbps UNI ModulePort Type Mode Status--------------------------------------4. 1 UNI disabled UP-OKAY4. 2 NNI enabled UP-OKAY4. 3 UNI disabled UP-NO ACTIVITY4. 4 UNI disabled UP-OKAY----- more -----Port display for module ONcore ATM 1 Mbps UNI ModulePort Type Mode Status--------------------------------------12. 1 NNI enabled UP-OKAY12. 2 UNI enabled UP-NOT IN SERVICE12. 3 SSI disabled UP-NO ACTIVITY12. 4 SSI disabled UP-OKAYONcoreATM>5-33