3Com 6416SW Installation And User Manual

Installing the 6416SW ModuleTo install a 6416SW module in the ONcore hub, follow these steps:1. Install the ONcore hub in its rack or on a desktop by following the instructions in the3Com ONcore Hub Installation Guide (17-00362).2. Insert the 6416SW module into slots 9 and 10 (or slots 11 and 12 in A17 models) ofthe hub by matching the top and bottom board guides as you slide the modulecleanly into place (by pressing evenly on the top and bottom of the faceplate). Donot attempt to push the module all the way into the hub until you have verified thatthe top and bottom module ejectors are OPEN (see Figure 2-2 on page 2-4.)3. Make sure that the module is plugged into the connectors on the ATM backplane.STATSTATRESETRESETMODULERESETMODULERESETACTIVITYACTIVITYPO RT1 PO RT11 12 23 34 4PO RT2 PO RT2PO RT3 PO RT3PO RT4 PO RT41 2 3 4 5 6 7 8 9 10 1112 13 14 15 16 17SlotsRS-232CONSOLERS-232AUXILIARYWRONGSLOTA-SCPSWSTBYRUNNINGACTIVEMAINTRESETATMRESETERRORFigure 2-1. Installing the 6416SW Module in an ONcore Hub2-3